Cannon/Std Bellhousing — (4 Disk)

5 disk is shown — measurements are for 4 disk.
A) release bearing clearance –> foot off of pedal, cannon extended .3 – .5″
B) base Arm offset = .1″
C) pressure plate thickness (donut) = 1.0″ ( .75 – 1+)
D) clutch pack 2.35″
E) flywheel 1.15″ (varies)
F) clearance flywheel to engine plate .06″
Total 5.2″ Starting position for release bearing from back of engine plate

A) release bearing cwidth .8 – .9 ” (BCA-2005-35)
B) bearing collar = .5″
C) AFT adjustment is internal (accessible threw top of body)
> AFT cannon does not have an extensine to adjust the bearing clearance it limits the stroke instead.
D) Stroke (fully extended) = 1.35″ – 1.6″ Adjustable
Total 2.95″ Starting position for release bearing from back of bellhousing

Total width (clutch cannon etc.) inside bellhousing is aprox 8.3″ same as space inside of the bellhousing
Note: front plate is made to fit stock small bellhousing opening

A) release bearing cwidth .8 – .9 ” (BCA-2005-35)
B) bearing collar = .5″ – .7″
C) adjustment is infront of sleave .25″ (0 – ,5″) (accessible threw bellhousing)
D) Stroke (fully extended) = 1.85″ (Adjustable by adding spacers inside to limit travel)
Total 3.4″ Starting position for release bearing from back of bellhousing

Total width (clutch cannon etc.)inside bellhousing is aprox 8.6″ requires a spacer in front of the bellhousing. (.25+)