We have been keeping busy through the year enhancing our production line, here is a look back at what we made and what we are capable of doing.
Barrel Valve Adjusters: These are handy tools that are easy to use and allow adjustment equal to 1/6th a turn with a nut.
Blow Back Tubes: These double o-ring quick disconnect pieces allow for a efficient puke tank removal from the Valve Covers.
Resurfacing Starter Dogs: We all have those starter dogs that have the tip rounded from use, we have a Jig and a program to clean them up to almost new.
Dual Carb Bracket: Not much to be said, Accuate and easy to install.
Floater Cutter Regroving: We have A jig to recut your old Floaters, and we also can resurface them along with Clutch Discs and the plates on the Flywheel and Pressure Plate.
Injector Spacer For Nostalgia Funny Car: This was a special project, plenty of thinking had to go into this to get the angle correct to Body.
Lightning Shifters: A compact and clean base that is fitted for air lines, and custom handles that allow for easy access to shift. FOR a B&J Trans
Custom Piston Rack With Tray For Caps: This was an amazing result from a desire to find a Rack that could sit on our block without the risk of falling over. keeps everything clean and is light, also quickly disassembled for those with minimal storage. Numbered and joined by a little tray so the crewcheif can inspect the bearings without clutter. The tray is also spill resistant.
: Spent some time talking to our Division Chassis Inspector and checked out some of his tools and developed these bad boys. Quick tubing checkers that hang hang on a keychain.
NOTE: We also have a Anodizing System for most of our pieces that we make, if your looking to add a personal touch to our products let us know!
- Log in to post comments